With the narrowing of the project's emission reduction potential during the “Twelfth Five-Year Plan” period, the rigid growth of economic development and resource and energy consumption will continue, and the actual emission reduction of major pollutants will be above 30%-40%. "Accelerate the pace of desulfurization and denitrification in other industries." Promote the total control of sulfur dioxide emissions in the steel industry, fully implement the flue gas desulfurization of the sintering machine, and build a new desulfurization and denitration facility. Strengthen the treatment of sulfur dioxide and nitrogen oxides in cement, petroleum and petrochemical, coal chemical and other industries. This is the content of the relevant person in charge of the Ministry of Environmental Protection's Planning and Finance Department on the “Twelfth Five-Year Plan for National Environmental Protection” on February 1. Many of the contents are closely related to the ceramic industry. In fact, as early as two years ago. On September 27, the "Ceramic Industry Pollutant Emission Standards" (hereinafter referred to as "Standards") formulated by the Science and Technology Standards Department of the Ministry of Environmental Protection was issued. It was implemented on October 1 of the same year. The special document specifies the ceramic industry enterprises in detail. The requirements for water, air pollution emission limits, monitoring and monitoring, etc. The introduction of this standard, for the first time, regulates the air pollution, water pollution and pollutant emissions produced by the ceramic industry, which has become a ceramic enterprise. The first national standard for pollutants generated during the production process. In the past two years of the implementation of the standard, the ceramic industry has less publicity about the Standard, and the actual implementation is little known. When inquiring about this Standard, it was found that the new emission limits were implemented in the multiple emission tables in the Standard from January 1, 2012, and the new limits were The standard is lower. In other words, the new standard will be more stringent. According to the production cycle of ceramic enterprises, after the Spring Festival, it is the beginning of the next year. Therefore, the beginning of 2012 is based on the newly implemented environmental protection policy. The new "standard" new limit is implemented from January 1, 2012, and the standard is more stringent. "From January 1, 2011 to December 31, 2011, the benchmark drainage limit for building ceramic polishing products. The value is 1.0, the non-polishing type is 0.3, the sanitary ceramic 6.0, and the special ceramic 2.0. "This is the standard for the concentration limit of water pollutants in existing enterprises and the standard for the displacement of building materials. However, from January 1, 2012, existing enterprises will implement new standards. "Building ceramic polishing The base product displacement limit is 0.3 for non-polishing products, 0.1 for non-polishing, 4.0 for special ceramics, and 1.0 for special ceramics. The result of the comparison is that the new standards implemented this year are obviously stricter than before. The water pollutant discharge limit will be implemented from January 1 this year, and the air pollutant discharge limit will also be implemented. Standard. "From January 1, 2011 to December 31, 2011, the limit of atmospheric pollutant emission concentration of existing enterprises is 500 sulfur dioxide for coal water slurry and 100 for particulate matter; from January 1, 2012, existing The limit of atmospheric pollutant emission concentration implemented by enterprises is 300 sulfur dioxide in coal water slurry and 50 in particulate matter. "The biggest pressure and risk for domestic enterprises in 2012 may not come from the market, but from this standard. If strictly implemented according to this standard, a large number of SMEs are difficult to survive. Chen Xianhui, vice president of the New Pearl Ceramics Group, is extremely concerned about the new standards to be implemented this year. She also said that the starting point for the introduction of such standards by the state is very good, but the implementation of the standards is too strong. "This standard is a world-class level. Most companies lack technical support and government support, how to achieve this standard? So this will undoubtedly bring great risks to the survival of enterprises. "In order to prevent the dilute emission of ceramic wastewater from ceramic enterprises, this standard has set strict limits on COD, BOD5, ammonia nitrogen and total nitrogen. If ceramic enterprises do not take effective measures to treat domestic wastewater in the plant area and Separate discharge of process wastewater will make it difficult to meet the limits specified in this standard. "This is an industry person's interpretation of the "standard" in the forum. He also believes that it is difficult to reach the limits of many of the indicators. "Environmental governance is a process of relying on gradual and technological progress. It cannot be across the board, nor can it be without foundation. The rush is to complete, otherwise the company faces great risks. Chen Xianhui once again stressed that the formation of environmental reversal mechanism, the company's huge environmental protection pressure and environmental protection situation is tightening year by year. It is an indisputable fact that ceramic production as an industry is inevitably bound by environmental protection policies. At the same time, the ceramic industry is producing. The wastewater and waste generated in the process have become the focus of environmental protection supervision. After the introduction of the Standard, the State Council issued the “12th Five-Year Plan for Energy Saving and Emission Reduction Comprehensive Work Plan” in September 2011, and subsequently introduced it. The "National Environmental Protection "Twelfth Five-Year Plan" and "Twelfth Five-Year Plan for the Reduction of Major Pollutants in the Twelfth Five-Year Plan", etc., have introduced a large and strong environmental protection binding force for the ceramic industry. If coupled with the new "Standards" implemented from January 1 this year, the environmental pressure on the ceramic industry is not too small. It is no wonder that Chen Xianhui, a leader of large enterprises, listed environmental protection as the main factor affecting the development of enterprises in 2012. At the beginning of this year, the State Council promulgated the "National Environmental Protection "Twelfth Five-Year Plan" for China's next five years. The development of the environment gives macro guidance, in which seven indicators including the total emission control indicators of sulfur dioxide and nitrogen oxides, two surface water environmental quality indicators, and one atmospheric environmental quality index are used as the main assessment items. At the end of 2013 and the end of 2015, the mid-term assessment and final assessment of the implementation of the plan were carried out separately. The assessment and assessment results were reported to the State Council and announced to the public, and as an important part of the assessment of local government performance. The person in charge of the Planning and Finance Department of the Ministry of Environmental Protection introduced the implementation mechanism when interpreting the National Twelfth Five-Year Plan for Environmental Protection. If the planning indicators are linked to the performance, the implementation of the enterprise will be stronger and stricter. Foshan City Han Fuxing, deputy secretary-general of the Ceramic Society, feels that the current environmental protection situation facing the industry is “environmental policy is forced” and that this atmosphere has been formed. From the local government accountability system of the National Environmental Protection 12th Five-Year Plan According to the implementation mechanism, his view is very correct. "In 2012, the development of building ceramics needs wisdom, and it is necessary to use wisdom to resolve the energy pressure, environmental pressure and export pressure in the development of the building ceramics industry. The “Twelfth Five-Year Plan for Building Sanitary Ceramics” lists three key projects of the building sanitary ceramics industry, namely, new product development projects, standardized raw material base construction projects and green manufacturing demonstration projects. The core of the three major projects is still wisdom. How to create innovative environment under the green background, we need to create an innovative environment, cultivate innovative talents, establish innovative mechanisms, need to change the dilemma, break the talent mechanism cage, and need people-oriented innovation. The sea. "Korean Renaissance solves the pressure exerted by the industry to break through the environmental protection." Secondly, the ceramic industry needs to erase the dust on the face through energy-saving emission reduction, clean production, recycling economy and other modes, and take off the sword at the top of the head. . As a technician, I recommend implementing innovations in resources, energy, equipment, technology, product structure, marketing model and management. "Environmental policies have been issued, and ceramic companies have shuffled their cards." This is the judgment of the media on the environmental impact of the ceramic industry. In the past two years of the implementation of the Standard, no enterprises have closed down due to environmental pressure, but if This year, the implementation of strict "standards" will inevitably lead to the closure of a number of enterprises. "If strictly implemented in accordance with the standards of the "Code", it is expected that more than 10% of small and medium-sized ceramic enterprises will be eliminated. "An industry person gave specific data on the impact of the implementation of the Standards on enterprises.

Lens Ring

Lens Ring,Lens Ring Joint Gasket ,Lens Gasket,Lens Ring Gasket

WENZHOU JINGWEI SEAL TECHNOLOGY CO., LTD , https://www.ringjoint-gasket.com

Posted on