First, test drive 1. Prepare for the test before the test. 2. Check that the components are installed securely. 3. The direction of rotation of each machine should be in the direction indicated by the arrow (the direction should be jogged). 4. Check if the cooling water is unobstructed. 5. The V-belt adjustment is suitable for restarting. After working for 50 hours, adjust it again. 6. Add grinding media from the top of the barrel. 7. Start the feed pump first, and then input the material to be discharged on the top screen before starting the main machine. 8. After a long time of parking, when restarting, the solid particles and the grinding medium in the material are often settled to “clamp†the disperser, especially When the viscous material is at a lower temperature, the "brake" phenomenon is particularly serious. At this time, when the jog motor cannot be started, the application hand is supplemented by the spindle pulley "crank" to input a small amount of solvent having the ability to dissolve the material, so that the material is loosened and then started. In short, you can't force it to start, so as not to damage the appliance and the body. 9. The parking time is longer, and the materials dried by the screen should be cleaned. 10. Clean the disperser and only rotate it slightly and intermittently, because the disperser and the grinding medium are very easy to wear and break in the fast running in the cleaning solution. 11. When using new grinding media, sift it to remove foreign matter such as foreign matter fragments. Second, the fault 1. The feed pump does not start or stops during work: A: Whether the power is turned on; B: Whether the fuse is blown. 2. The host cannot start or stop at work: A: Whether the fuse is blown; B: Whether the feed pump feeds C: Is the V-belt too loose; D: Whether the disperser is stuck. 3. Motor load is too large: A: Whether the viscosity of the material is too high; B: Whether the grinding medium is excessively loaded C: Is the electrical circuit normal? 4. Feed pump does not feed: A: Whether the pipeline is leaking; B: Whether the feed pipe is blocked C: Whether the feed pump has been seriously worn; D: Whether the viscosity of the material is too high. 5. Reduced production efficiency: A: Is the grinding medium too small; B: Is the disperser excessively worn? C: Whether the grinding media is largely broken.
Main Type
* To North/South American market
This rail spike is manufactured according to ARMEA specifications or customers' requirements.
Size: 3/4", 1/2", 5/8"
* Material to Grade 5.6 or at customers' requirement, mainly supply to Eurpo
Size: 12X12X115mm,etc
Surface: Plain,etc
*To GOST 5812-82
Standard: GOST 5812-82, stand a tensile strength of 49KN(5ton force)
Size:16X16X165/205/230/280mm, etc
Surface: Plain,etc
*Main supply to Sweden
Size:16X16X170mm, etc
Surface: Plain,etc
* Boat spike
Size:3/8X3/8X6"/8"/10", 1/2X1/2X10"/12"
Material: Q235,etc
Surface:Plain, black, Galvanized, etc.
Track Spike,Dog Spike,Rail Spike,Boat Spike TAICANG ZHONGBO RAILWAY FASTENING CO., LTD. , https://www.railfastener.com
Length: 3", 3-1/2", 4-1/2", 5", 5-1/2", 6",etc
Material: Q235, 35#, Q355, etc.
Surface: Plain,etc
