Simulation Giraffe Lights,LED Giraffe Lights,Simulation Garden Giraffe Lights,Outdoor Giraffe Lights of Garden Sichuan Kangruntengpu Photoelectric Technology Co., Ltd. , https://www.krtoplighting.com
Advantages and characteristics of electromagnetic heating systems
1. Significant energy saving A layer of thermal insulation is installed between the high-frequency heating induction coil and the barrel. Most of the heat inside the barrel is used, and only a small amount of radiation is radiated into the air. The temperature of the surface of the barrel is generally between 50-80 degrees. After rigorous experimental tests, the energy saving is 30%-80%, especially for the high-power injection molding machine.
2, significantly reduce the temperature of the workshop Through the above energy-saving analysis, the use of high-frequency heating system not only improve the energy saving of the equipment, but also improve the temperature of the entire workshop, so that employees work in a more comfortable environment;
3, rapid heating, accurate temperature control The traditional principle of resistance wire heating is that the resistance wire itself generates high temperature, and then the heat is slowly transferred from the outer surface of the barrel to the center of the barrel, the speed is slow, and the actual temperature of the plastic at the center of the barrel There is a large error in the surface temperature of the barrel. The working principle of the high-frequency heating system is to make the metal barrel itself heat, the heat energy is generated by the whole metal of the barrel, the temperature control is real-time and accurate, and the temperature inside and outside the barrel is consistent, which obviously improves the quality of the product and improves the production efficiency;
4, can work in harsh environments for a long time, the traditional resistance wire of plastic machine barrel is used in the following environment to reduce its life. Such as: the heating position encounters oil pollution, the barrel metal heat conduction is poor, and the glue leakage phenomenon. Since the high-frequency heating system itself does not generate heat, it does not heat-carbonize the oil stains, plastic particles, etc. adsorbed on its own surface, so that no leakage or short-circuit failure occurs;
5, the heating power is large, the traditional resistance wire of the plastic machine barrel is too large, the damage to the resistance wire itself will increase, the resistance wire metal itself will quickly evaporate at high temperature, quickly aging and fail, so the traditional resistance wire needs Irregular replacement, and the characteristics of the high-frequency induction heating system is that only the metal inside the barrel that is induced is heated at a high temperature, and its own electrical loss is small, so the power consumption does not affect the service life of the high-frequency heating system. It is necessary to adjust the power used.
6, to avoid the unsafe factors of traditional heating, after using the high-frequency heating system, the temperature of the surface of the cylinder is below 50-80 degrees, the human body can completely touch safely; avoid the occurrence of burns and burns caused by the traditional heating method; 