When the bolt is immersed in the plating tank, the electrolyte penetrates into the gap and is not easy to clean. After the bolt is left for a period of time, the electrolyte will flow out and interact with the electrolytic layer. Corrosion of the electrolytic layer causes the electrolytic membrane to be destroyed, and a large number of black patterns appear, reducing The protection of the coating on the bolt and the strength of the coating. The influence of electro-galvanizing process factors The hydrogen evolution and hydrogen permeation are unavoidable in the whole electroplating process. Because the bolts are electroplated, hydrogen and zinc are co-precipitated on the cathode. Most of the hydrogen escapes as hydrogen bubbles, but there are still A small part of hydrogen enters the zinc coating in an atomic state and enters the metal matrix lattice along the grain boundary to produce hydrogen permeation. During the electroplating process, hydrogen intrudes into the matrix mainly when the plating layer is thin, or penetrates into the matrix along the defect. The thickness of the plating of the inspection bolt reaches 1424Lm. Why can't it prevent the large amount of hydrogen from penetrating the surface of the metal substrate to a deeper color, and some places even become purple-red, which indicates that the plating layer is not pure. The lattice is distorted, creating large internal stresses and reducing the toughness of the metal matrix. Impurities such as silicon, sulfur, and calcium in the plating layer make the plating layer high in hardness and brittle. The microscopic defects of the bolt formed by the heat treatment exacerbate the hydrogen permeation process of the bolt. There are brittle fractures along the crystal, ductile fractures, and flattened areas. It shows that when the bolt has microscopic defects, the crack source is formed. When the work is subjected to external force, the crack expands along the region where the amount of hydrogen infiltrated (such as grain boundary, defect, etc.), forming brittleness and intergranular fracture.
Sealand is a professional supplier of Water Mass Flow Meter, Beverage Mass Flowmeter, Water Mass Flowmeter, Beverage Mass Flow Meter, Palm Oil Flow Meter, ATEX, IECEx & CE approved.
It has self-diagnosis function.
The transmitter & software will self-diagnose once powered on/ connected.
Please keep the meter in good condition during transport, better packed in the original
package from the manufacturer.
a) Waterproof and moisture-proof;
Water Mass Flow Meter, Beverage Mass Flowmeter, Water Mass Flowmeter, Beverage Mass Flow Meter, Palm Oil Flow Meter Zhejiang Sealand Technology Co., Ltd. , https://www.sealandflowmeter.com
The transmitter will show error code immediately on the top of display if there is anything
wrong.
1.Error 01: Sensor error; 2.Error 02: Temp. sensor overrun;
3.Error 03: Zero failed; 4.Error 04: Transmitter initializing.
To callout the interface on software, click tool bar > Functions > Status. The light in front is
green when everything is fine, but will be red if there is any error.
Please make sure the site meets following requirements, if keep the meter in storage.
b) With few mechanical vibration and crush;
c) Temperature from -30°C to +65°C;
d) Humidity less than 80%, better about 50%;
e) Please clear up the sensor if storage used one;
f ) Performance will be influenced if storage in the open.