The most important thing we pay attention to is the visual effect after the decoration. The final effect of the floor tiles is decided by the floor tile products and the paving construction. Although we all know that the tiles need to be checked before paving, we must not forget the acceptance process after paving. When many friends accept the effect of paving tiles, they often rely on their eyes and hands to touch them again. They find that there are no big problems on the line. In fact, it is necessary to know that such acceptance is very irregular. Therefore, the following Xiaobian introduced the method of laying bricks for everyone.
A tile soak
First clean the tiles and soak them for more than 2 hours. Soaking is to allow the tiles to fully absorb enough moisture so as not to absorb the moisture in the material after the paving is completed, resulting in insufficient moisture of the adhesive and affecting the firmness of the adhesion, thereby causing hollowing and falling off. The tiles need to be removed from the water and wiped off the surface moisture before the tiles are fully immersed and before the tiles are laid for paving.
Second, set up the auxiliary line
Before starting to paving, suspend a vertical line on the wall screed to determine the tile's line size. Then set the horizontal line, so that you can ensure that the tile is laid horizontally and vertically and the surface is flat.
Third, set the support board
When laying ceramic tiles, horizontal lines are used as guidelines, and a wooden board that can support the tiles is provided to prevent the tiles from displacing or falling before reaching the adhesion strength.
Fourth, according to the order posted
Tiles are generally laid out by the edge of the door (or balcony), from top to bottom, from left to right. The specific paving method is: first leveling the layer with water, using a shovel to put the mortar (or other adhesive) on the back of the tile, and then paste the tile on the wall, then tap the tile with a shovel handle or rubber hammer, Fill the space between the walls and the tiles with the mortar.
Note that the mouth should be aligned with the horizontal line. If it is missing, it can be adjusted by placing small pieces of wood under the tiles. After using one line, use a ruler to cross it and level it. The upper part is hammered with a hammer, and the undercut is filled again to ensure flushing. The sticky material should not be too thick or too thin. Too thick to be easy to spread, too thin to stick.
V. Cleaning and maintenance
The stains and dust on the surface after the floor tile is finished need to be cleaned in time. Here are some methods for cleaning and maintenance. In the case of serious surface contamination, especially stained with hard-to-remove stains, it can be wiped with 10% dilute hydrochloric acid solution. If you use dilute hydrochloric acid, you must finally rinse it with tap water. After the tile glaze is cleaned up, a thin layer of brightener can be sprayed on the surface of the tile and wiped again with a soft cloth to keep the tile surface bright and free from contamination.
It should be noted that the mud slurry and other debris in the brick joints should be promptly cleaned when the floor tile is attached, and the stains should be wiped off with a damp cloth. If you wait until the slurry is hard and then clean up, it will not only take time and effort, but will have poor results, and it may even cause permanent damage to the glazed tiles.
Editor's summary: The method for laying floor tiles is introduced here. I hope to be helpful to everyone. If you want to know more related information, you can pay attention to this website information.
Brick
Urinal Flush Valve
Urinal flush valve is made of brass, chrome plated. Press down for water, delay time 6 to 8 seconds, then automatic closed. It often use for hung Urinal in public washroom. Exposed type flush valve looks simple, easy to install and operate. Working pressure should be 0.05MPa to 0.9MPa.
Exposed Urinal Flush Valve,Concealed Urinal Flush Valve,Automatic Urinal Flush Valve,Urinal Flushing System
SHENZHEN KING OF SUN INDUSTRY CO.,LTD , https://www.handyfaucets.com