Socket wiring installation specification socket how to connect

We all know sockets, because sockets are indispensable for our daily life. Sockets in our homes are usually of the two-hole type and three-hole type. Many people directly connect this hole to the terminal when wiring the socket . The zero line in the socket is connected, which is a very dangerous behavior. Then the following to understand the socket wiring installation specification and how to connect the socket.

First, the socket wiring installation specification

1. The socket connection is best not to do it yourself when we are not particularly aware of it, so as not to hurt ourselves and be responsible for our own life safety. The bottom edge of the door switch box shall be 1.2m-1.4m away from the ground. The distance between the door and the door must be greater than 70mm. The switch for the special location shall be installed according to the owner's requirements. The safety socket shall be used when the bottom margin of the socket is less than 1.8m.

2. The environment in some parts of our home will be relatively humid. At this time, the socket wiring should be used to protect the socket by using a sealed type. The installation height of the socket should be ≥ 1.5m. In the children's room, safe sockets should be used. When calculating the load, all outlets without a fixed load body are calculated at 1000 watts. The common socket uses 2.5mm2 copper wire. Permissible deviation of panel verticality ≤ 1mm.

3, as long as it is the socket must face the direction of the panel to connect the zero line, right to the phase line, three holes plug the upper ground. The exposed copper wire shall not exceed 1mm in the box. The switches and sockets shall avoid the modeling wall surface. After the switch is installed, it shall be convenient to use. The same room switch shall be installed on the same horizontal line and be arranged in the most common and rarely used sequence. .

Second, socket wiring - how to connect the socket

1. How to connect the socket Generally, few people will need to understand this problem, because most of the families who want to install sockets will ask professional staffs to perform wiring, of course, some people want to know. Single-open five-hole switch, red line, blue line are respectively FireWire, zero line respectively, connect the socket connection L and N, yellow and green two-color line to the socket terminal protection line, and then use short-term access to the socket L terminal and switch terminal L, in addition A wire led from the bulb is connected to the switch terminal L1.

2, then is a single open three-hole switch and single-open five-hole procedure is almost the same, but the single open five-hole internal socket has been connected to the FireWire and the zero terminal, if you do not ask for their own homes When the wiring does not wear protective wires, then the outlets are not connected to the protective wires.

Summary: The relevant information about the installation specification of the socket wiring and how to connect the socket is introduced here. I hope this helps everyone. If you still don't understand the place, you can pay more attention to it. If you want to learn more about building materials, please keep an eye on our website.

Transparent Masking Film With Tape

Our protective Transparent Masking Film With Tape roll is great for dust and overspray containment. Is easy to unfold and use. Use to mask baseboards and trim. Use automotive aftermarket. Saves time and money.

Waterproof Transparent Film,Antistatic Film Tape,Auto Easy Masker Masking Film

GUANGZHOU SUNPLUS TECHNOLOGY CO.,LTD , https://www.sunplussandpaper.com