kaiping aida sanitary ware technology co.,ltd , https://www.kpfaucets.com
The maintenance and maintenance work of the three roller gates directly affects the service life of the three roller gates. Therefore, the time maintenance and maintenance work of the three roller gates should not only be done but also be done as required. Many users have been neglecting or failing to perform normal maintenance of the machine since they started using the three-roll gate. As a result, some parts are not replaced due to lack of timely lubrication and replacement. Parts and maintenance machines, so that because of small losses, so the user must understand the importance of maintenance of the three roller gate in use.
II. Points of Attention for Maintenance and Maintenance of Three-roll Gates We have summarized the maintenance and maintenance of the three-roll gates in the following order from the outside to the inside:
First, the external maintenance of the gates The three roller gates on the market are made of domestically produced SU304 stainless steel. This material has the characteristics of rust prevention and durability. The cleaning frequency can be set once a week: it is mainly the appearance of cleaning, remove rust spots, use a soft cloth and fossil powder to polish the outer surface of the chassis, apply anti-rust oil, just do not rub the anti-rust oil on the hand, etc. 3- 5 hours natural drying can be hand contact, otherwise it will destroy the surface rust effect. If the paint is a three-roll gate, the same color anti-rust paint can be used for repair work after the surface paint layer is found scratched.
Second, the internal movement of the gate maintenance movement as the heart of the machine must be well maintained. The maintenance frequency is generally maintained once a month: Open the top cover and cut off the power supply, clean the surface dust, and then clean the transmission part and add grease or high-concentration oil to lubricate. Check whether the fasteners are loose, tighten the fasteners, check the wearing condition of the wearing parts, and find that the worn parts exceed the specified parts and replace them in time. Check whether the positioning arm and the positioning plate have more than 3mm clearance, such as There is a timely replacement (normal clearance of 1-1.5mm), solenoid valve appropriate amount of butter or oil, so that the solenoid valve in the left and right movement is to reduce resistance, get lubrication, do not add too much, should be appropriate.
Third, the internal circuit part of the gate maintenance According to the previous use, see if there is a problem in the electronic control part, no problem, then check whether the power is exposed to be bandaged, the wire to be arranged, whether the aging of the wire, be replaced, refer to the three roller gate Manual, check the parameters of each department. If you have problems, you must follow it, find the source of the problem, and replace individual electronic components.
Special attention is paid to the fact that in order for the maintenance and repair of the triple roller gate to be standardized, safe, and detailed, special personnel must be responsible for the maintenance of the gate, especially the maintenance of the electronic control part, and trained professionals must be responsible for the electronic control. The principle is fully understood before the job can be performed.
A: The significance of the maintenance and repair of the three-roll gate We know that the machine will produce more or less loss during use, in addition to the correct and reasonable use of the instrument in the operation process, the maintenance of the machine is also It is of utmost importance because the maintenance of the specification ensures that the instrument runs stably and smoothly during use, and it can avoid or reduce the impact of corrosion, rust and Other unfavorable factors on the machine when idle.