Electric Hand Drill,Electric Angle Drill,Powerful Electric Drill,Variable Speed Electric Drill ZHENGYANG TECHNOLOGY CO.,LTD , https://www.supraone.com
The first step is to check. When the system's terminal pole, middle pole, ground wire, detector, etc. are all installed, a comprehensive inspection should be carried out. Check whether all poles are firmly installed, whether the stainless steel wire is erected properly, check whether the grounding device is good, whether the grounding resistance meets the requirements, and check whether the signal cable and the power cable have been well connected and connected. After the tension fence perimeter system is fully energized, check the status of the tension indicator, adjust the tension of the tensioner, and the tension indicator should remain off. When an intruder invades when all the defense zones are in the alert state, there will be a line break, and the tension indicator will flash when the line is disconnected, indicating that there is a corresponding alarm situation. Alarm signal, there will be corresponding words on the alarm host to display the alarm situation and the alarm host will also issue a siren sound to remind the security personnel, and output a switch signal to drive other equipment to work. If the zone detector fails, the power is lost or the communication line is damaged, the alarm panel will display the corresponding words to remind the duty personnel to check in time. 
Next is the wire break alarm test. After debugging the system, use a tool to unscrew the wire-to-wire connector to disconnect the high-voltage wire from the alloy wire on the fence. During the alarm test, the stainless steel wire is pulled by hand or objects for 2 seconds, the detector will alarm, and the alarm condition will be displayed. At the same time, the host will be alerted.
The tension type electronic fence can always be loyal to its duties in harsh environments such as wind and frost, rain and snow, dense fog, sand and dust, high temperature and low temperature, and work stably and reliably around the clock. Compared with the pulse electronic fence, the front-end device of the tension electronic fence is not charged, but it can also detect and block the intruders from climbing. Because the tension fence is used to detect the invasion of climbers based on the change of the tension value, it is basically not affected by the environment and so on, and successfully avoids the shortcomings of many environmental detection products in the past that are affected by the environment. Today, let us take a look at how to check, test and maintain the tension electronic fence after installation!
After that, the electronic fences are regularly disposed of around garbage and the tension line is tightened when the seasons change, to prevent thermal expansion and contraction from affecting the accuracy of the tension electronic fence!