Chemical Pump,Chemical Metering Pump,Chemical Feed Pump,Chlorine Injection Pump Hengshui Yuanhan Trading Co.,Ltd , https://www.hengshuiyuanhanpump.com
/*728*90 created on 2018/5/16*/ var cpro_id = "u3440131"; Home>Bearing knowledge>Removal of the bearing cover of the motor Method of disassembling the bearing cap of the motor
1. It is very simple to disassemble the bearing cover; just unscrew the screws that fix the bearing cover; you can remove the front and rear bearing covers. The front and rear bearing covers should not be marked off the mark; avoid the wrong installation before and after installation. /*250*250 was created on 2017/12/25*/ var cpro_id = 'u3171089';
2. The installation method of the bearing cover is: the outer cover is placed outside the end cover through the rotating shaft; a screw is inserted; the screw is supported by one hand; the rotating shaft is changed by one hand; the inner cover of the bearing is also turned to the outer cover When the screw holes are aligned, the screws can be inserted into the screw holes of the inner cover and tightened; finally, the other two screws are also tightened.
Recommend to friends comments close window Bearing related knowledge Bearing device common sense bearing classification details (1)
The fine grinding machine spindle angle bearing replacement method details the application of "motor bearing" and the characteristics and application of the selected angular touch ball bearing
This article links to http://
Please indicate the bearing network http://
Previous:The effect of the smooth oil of the car smooth oil maintenance treasure book Next:The bearing dismantled the "small science"
Source: China Bearing Network Time: 2014-01-02