Cm Lodestar,Electric Hoist 1 Ton,1 Ton Electric Chain Hoist,2 Ton Electric Chain Hoist Guangdong Gongyou Lift Slings Machinery CO.,LTD , http://www.gongyouslings.com
Slurry pump is a category of more pumps, derived from many branches, each branch of the slurry pump has its own special working principle, therefore, Xiaobian tell you about the classification of slurry pump and The general principle of work. What is the classification and working principle of the slurry pump? (A) Classification of slurry pump Divided from the number of impeller: single-stage slurry pump and multi-stage slurry pump. Divided from the pump shaft and horizontal plane: horizontal slurry pump and vertical slurry pump. Divided into the way from the inhalation of water: single suction slurry pump and double suction slurry pump. From the pump housing structure: single-shell slurry pump and double-shell slurry pump. (B) the working principle of slurry pump First tell about the relationship between the centrifugal pump and the slurry pump, and then the principle of slurry pump will naturally clear. The concept of centrifugation is based on the principle of the pump. There are many types of pumps, depending on the angle can be divided into dozens of categories. Centrifugal pump is divided from the working principle of the pump, through the centrifugal force to achieve the process of supercharging the transmission medium. There are also other common types including screw principle, plunger principle can be divided into different centrifugal principle of the pump. Finish the concept of centrifugal pump, say the slurry pump, slurry pump is divided from another point of the pump, that is divided from the transmission medium. As the name implies, the slurry pump delivers a mixture of solid particles containing water and water. However, in principle, the slurry pump is a centrifugal pump. Centrifugal pumps are the main components of the impeller and the casing, the casing of the impeller device is located on the shaft, and connected with the prime mover to form a whole. When the prime mover drives the impeller to rotate, the blades in the impeller force the fluid to rotate, ie the blades work on the fluid along its direction of motion, forcing the pressure potential and kinetic energy of the fluid to increase. At the same time, the fluid flows under the force of inertia from the center to the edge of the impeller and flows out of the impeller at a very high speed into the pressure chamber, which is then discharged through the diffuser tube. This process is called as pressure watering. At the same time, due to the flow of fluid in the center of the impeller to the edge, a low-pressure zone is formed in the center of the impeller. When it has a sufficient vacuum, the fluid enters the impeller through the suction chamber under the pressure of the suction end (generally, atmospheric pressure) Water absorption process. Due to continuous rotation of the impeller, the fluid is continuously discharged and sucked in to form a continuous operation. Centrifugal pumps (including the slurry pump) work process, in fact, is a process of energy transfer and conversion. It transfers the mechanical energy of a motor rotating at high speed through the blades of the pump and translates into the pressure and kinetic energy of the fluid being pumped. (Editor: Huang Nengwen QQ :)