Steamed wine will be fermented material liquid into the pot or special steamed wine pot, put iron shovel, cover flap, connect the gas bar and the condenser, with special attention to the joints must be sealed without leakage, leakage It is running alcohol. At the beginning of cooking, you should always push and pull the shovel, and try to change the angle to pull the bottom of the pot to avoid the liquid to precipitate the paste pan. After the pan is opened, you can use the cloth to tightly pull it. Holes to prevent runaways. The wine that has just started is the first wine, and the highest degree is. The lower the number, the lower the number. The degree of wine can be measured with temperature and alcohol. When the outflow of wine from the outlet pipe is lower than required, the bucket is used to make extra wine. When the wine is less than 10 degrees, the pot is completely cooked. The tail wine is added to the pot to boil and the same wine can be produced. Tail wine pot pot cooking cycle, will not be wasted. When steaming wine, it should be noted that the condenser must be circulated with cooling water, and the temperature of the outflowing wine should be controlled at about 20, so as to prevent the wine from being overheated and losing its volatility. When steaming begins, the fire should not be large, and it is recommended to burn the fire at the end of the day. The wine that has just been produced has a bad taste and must be blended after being mixed and aged before it can be consumed or sold. After the wine is distilled, remove the gas bar, release the steam, and finish the lees. If you want to steam the wine continuously, do not brush the pan; if you do not continue steaming, be sure to wash it clean, and use the fire in the stove to dry the pot, ready for reuse. If you want to use pot steam after going out of the pot, you should wash it to prevent it from sticking. The original silicon generator does not generate electricity, Chen Xiaoshu pole breakdown or internal rectification knot off, does not play the role of rectification. The brush is stuck in the brush holder so that the generator cannot be energized. This can be judged using the magnetic field of the universal test generator and the resistance value in the connection terminal. If the measured resistance value is close to the specified value, it is normal. If there is no indication on the ohm, it means that the excitation loop is not open. This is usually a brush stuck in the brush holder except for the interruption of the excitation winding. Excitation windings. If two universal universal test rods are directly connected with the two slip rings on the shaft, if they are still not connected at this time, it is very likely that the weld ends at the ends of the excitation windings and the slip rings fall off or the excitation winding leads out. Turn off at the turning point. Stator windings are short circuited or connected to the iron. Due to long-term work under heavy load conditions, the dipping edge of the lead wire of the lead wire group also falls off, causing phase-to-phase short-circuiting, or stator windings causing cracks in the windings to cause iron in the winding, causing the generator to not generate power. Excitation group short circuit. During the assembly process, the positions of the two brushes and the slip ring were not aligned. After the generator working time, the powder beam under the brush shorted the two slip rings, and even severely damaged the brush holder. Regulator failure. Adjustment voltage is too low, contact ablation, and a wire in the regulator is disconnected or de-welded, making the excitation circuit of the generator unusable. If the contacts are lightly ablated, they can be ground with glass sandpaper. 2.3 Farming Technology 35
Door and Window Pilasters/Fluted Pilaster are used as architraves for the doors. It exudes a classic elegance to the doors. Door And Window Pilasters provide flexibility to mix and match to your desired preferances.
You can transform a new door with DSM decor Door and Window Panel,Sliding Door Panels,Sliding Window Panels,Door Curtain Panels, PU Pilasters , PU fluted Pilasters, PU Column Pilasters,The architrave gives the door a stately look.
Door and Window Pilasters are usually discrete ornaments but they act much like picture frames to surround a view. various design and size are available.
Advantages:
1. PU (Polyurethane) material is Eco-friendly materials
2. Lasts longer than MDF or wood mouldings.
3. Designed for interior and exterior use.
4. Easy to install and will not crack, crumble, or warp.
5. Low cost: The surface painting is finished and installation time is very short, can be planned, sawed, nailed, and glued by yourself. 80% cost save than using wood and concrete.
6. Fire-proof: Reach the standard of no combustion.
7. Water-proof: No moisture absorbing, water permeation, and mildew arising.
8. Anti-erosion: Resist acid and alkali.
9. Light weight: good resiliene and tenacity, light and hard.
10. Styles and Colorful: Different Colors and Types are available.
Our Service:
1. Factory direct sale with excellent quality, reasonable price and first-class service.
2. Timely delivery to every corner of the world.
3. Strong supply capacity, high-tech skills and advanced equipment can surely meet customers` requirement.
4. Launching new designs for each category every year.
5. Exquisite workmanship. All products 100% inspected.
6. Preferential freight by Famous shipping company.
7. Excellent after-sales service.
Door and Window Pilasters Door And Window Pilasters,Door And Window Panels,Sliding Door Panels,Sliding Window Panels,PU Pilasters,Door Mouldings Suntronic New Materials Technology Co., Ltd. , https://www.dsmdecor.com