Fiberglass Measuring Tape,ABS Holder Measuring Tape,Rubber Fiberglass Measuring Tape HENAN BONTHE MEASURING TOOLS. CO., LTD , https://www.tapemeasurebte.com
/*728*90 created on 2018/5/16*/ var cpro_id = "u3440131"; Home>Bearing knowledge> Dynamic pressure bearing layout and selection Dynamic pressure bearing layout and selection
Analysis of several typical dynamic pressure bearing layout and application. /*250*250 was created on 2017/12/25*/ var cpro_id = 'u3171089';
1. Deep and shallow cavity layout dynamic pressure bearing: suitable for high speed and light load machine tool spindle; such as M1432 cylindrical grinding, MGA6025 thing grinding, etc.
2. Hole type torus saves deep and shallow cavity dynamic pressure bearing: suitable for medium speed medium load machine tool spindle; such as MG1432 cylindrical grinding, MM7150 flat grinding, M1080 centerless grinding, roll grinding, etc.
3. Pin-type internal reaction dynamic pressure bearing: suitable for machine tool spindles with large load and speed changes.
4. Conical hydrostatic bearing: suitable for high-speed internal grinding head spindle system (such as 2110 internal grinding head), electric spindle, and inner channel grinding machine.
Application Notes 1. 2# spindle oil and coarse fine filter should be replaced after one year of normal operation.
2. Normal use of the pump station to make up for the oil must be 3 layers of silk cloth filter to participate.
3. When the spindle pulley and the grinding wheel are loaded and unloaded, it must be carried out in the state of the pump station. That is, the spindle is carried out in the state where the static pressure oil floats. This does not damage the spindle and the dynamic pressure bearing.
4. Before the grinding wheel spindle operation, investigate whether the pump station pressure and the grinding head static pressure can be within the standard scale.
5. When the equipment stops, it is necessary to stop the grinding head motor first; after the grinding wheel is stopped, turn off the pumping station; otherwise, simply damage the grinding head.
6. Replace any parts on the pumping station; first remove the high-pressure oil inlet hose joint; after replacing the parts; the oil circuit can be self-circulating for 15-20 minutes before the oil inlet pipe can be connected to the grinding head; thus ensuring the entry into the grinding machine. The spindle oil of the head is ultra-clean spindle oil that has been finely filtered. This can extend the service life of the dynamic spindle.
Recommend to friends comments close window Bearing related knowledge KOYO bearing cleaning, overhaul and discriminating rolling bearing technical information How to support the bearing of the main roller of the sheetfed offset printing machine How to view the single-row angular touch ball bearing on the SKF bearing [Touch angle 35°]
This article links to http://
Please indicate China Bearing Network http://
Previous:Linear bearing LM and LME code base meaning Next: Bearing professor brief bearing false Brinell indentation
Source: Bearing network time: 2014-02-08